change

Current Selection: Please Select...

Please select from our gallery on the left and pick the tile you like.

Price: £... m²

Worktop Measurements

Please measure the length and width of each worktop piece that you require and enter them into the boxes below. Include any other units such as breakfast bars, island units etc. Price is based on 30mm thickness granite. Please ensure your measurements are in mm (1m = 1000mm).

Based on a 600mm depth the longest run we can guarantee without a joint is 2800mm for granite ( please enquire if large sizes required) and 3000mm for quartz stone,. These measurements may be reduced if there is a cut-out in the run.

Double Chamfer =

mm

Pencil Round =

mm

Half Bulnose =

mm

Full Bullnose =

mm

Dupont Edge =

mm

Cost = £0

Double polished cut-outs

Double polished cut-outs are cut-outs for two undermounted sinks next to each other that have the inner edges exposed and polished.

Undermount =

0 1 2 3 4 5 6 7 8 9 10

Belfast =

0 1 2 3 4 5 6 7 8 9 10

Cost = £0

Drop in hob

Quantity =

Cost = £0

Tap Holes

These are the cut-outs for taps and switch holes, i.e. waste disposal.

Quanity = 0 1 2 3 4 5 6 7 8 9 10

Cost = £0

Drainer Grooves (1 Set = 5 Grooves)

Drainer grooves are five straight grooves (1 set) in the worktop next to the sink which act as a draining board.

Quanity = 0 1 2 3 4 5 6 7 8 9 10

Cost = £0

Recessed Drainer

Double polished cut-outs are cut-outs for two undermounted sinks next to each other that have the inner edges exposed and polished.

Full Recess (Undermount) =

0 1 2 3 4 5 6 7 8 9 10

Half Recess (Belfast) =

0 1 2 3 4 5 6 7 8 9 10

Cost = £0

Total Length =

mm

Cost = £0

Splashback pieces

This is the granite panel which can be used behind the hob, range and sink to protect the wall from splashes. You can also have full height splashbacks which are positioned on top of the granite work surface to the underside of the wall units.

Measure the length and width in mm of each splashback piece that you require and enter them into the boxes. Price is based on 30mm thickness granite. Please ensure your measurements are in mm (1m = 1000mm).

Totals

Materials = £0
Fabrication = £0
Templating & Fitting = £0
Total Quotation = £0
Total including VAT (20%) = £0

Please note that this price is a guide only, there may be extra charges for shaping, special cuts and/or additional mileage costs for traveling further than one hours drive from our factories. There may also be a reduction in the templating, fabrication and fitting charge for very small jobs such as islands, vanity tops etc. For a more accurate quote please submit the form on our Online Enquiry Form page and ideally send us a kitchen plan.